Brocade Fabric OS Documentation Addendum v6.1.2_cee (53-1001216-01, June 2009)

Fabric OS Documentation Addendum 9
53-1001216-01
Chapter
2
Fabric OS Command Reference
In this chapter
•New commands in Fabric OS v6.1.2_cee . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
•Modified commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
•Notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26
•Command RBAC permissions and AD types . . . . . . . . . . . . . . . . . . . . . . . . . 27
New commands in Fabric OS v6.1.2_cee
Add the following new commands to the Fabric OS Command Reference for Fabric OS v6.1.1
(53-1000599-03).
cmsh
Opens the CEE command shell.
Description Use this command to open a shell for managing 10GE interfaces and L2/L3 protocol services. The
CEE management shell provides a hierarchical CLI interface.
Refer to the Fabric OS Converged Enhanced Ethernet Command Reference and the Fabric OS
Converged Enhanced Ethernet Administrator’s Guide for information on using the CEE commands
and configuration procedures.
Operands None
Examples To run FCoE using the minimum switch configuration:
switch:admin> cmsh
admin>en
admin>#conf t
Enter configuration commands, one per line. End with CNTL/Z.
admin>(config)#int te 0/0
admin>(config-if)#sw
admin>(config-if)#no shut
admin>(config-if)#exit
admin>(config)#exit
admin>#show ip int br
Interface IP-Address Status Protocol
TenGigabitEthernet 0/0 unassigned up up
TenGigabitEthernet 0/1 unassigned administratively down down
TenGigabitEthernet 0/2 unassigned administratively down down
TenGigabitEthernet 0/3 unassigned administratively down down
TenGigabitEthernet 0/4 unassigned administratively down down