Brocade Converged Enhanced Ethernet Command Reference v6.1.2_cee (53-1001217-01, June 2009)

Converged Enhanced Ethernet Command Reference 77

53-1001217-01

debug lldp packet

Enables debugging for Link Layer Discovery Protocol (LLDP).

Synopsis debug lldp packet {all | interface tengigabitethernet slot/port} [both | detail [both | rx | tx ] | rx |

tx]

no debug lldp packet { all | interface tengigabitethernet slot/port }

Operands all Turns on LLDP packet debugging on all interfaces.

interface tengigabitethernet Specifies the 10 Gbps Ethernet interface.

slot Specifies the slot number.

port Specifies the port number.

both Turns on debugging for both transmit and receive packets.

detail Turns on debugging with detailed information.

rx Turns on debugging for only received LLDP packets.

tx Turns on debugging for only transmitted LLDP packets.

Defaults By default, debugging is not turned on.

Command

Modes

Priviledged Exec Mode

Description Use this command to enable debugging for Link Layer Discovery Protocol (LLDP). Use the no

debuglldp packet command to disable debugging.

Usage

Guidelines

To display debugging outputs on a particular cmsh session, use the terminal monitor command.

Examples To enable debugging of LLDP for both received and transmitted packets on interface

tengigabitethernet 0/1:

switch#debug lldp packet interface tengigabitethernet 0/1 both

switch#show debug lldp

LLDP debugging status:

Interface te0/1 : Transmit Receive