Brocade Converged Enhanced Ethernet Command Reference v6.1.2_cee (53-1001217-01, June 2009)

54 Converged Enhanced Ethernet Command Reference

53-1001217-01

switchport mode

Sets the mode of the Layer 2 interface.

Synopsis switchport mode {access | trunk}

Operands access Sets the Layer 2 interface as access.

trunk Sets the Layer 2 interface as trunk.

Defaults There are no defaults for this command.

Command

Modes

Interface Configuration Mode

Description Use this command to set the mode of the Layer 2 interface.

Usage

Guidelines

There are no usage guidelines for this command.

Examples To set the mode of the interface to access:

switch(conf-if-te-0/19)#switchport mode access

To set the mode of the interface to trunk:

switch(conf-if-te-0/19)#switchport mode trunk

See Also show vlan brief, show interface switchport, switchport trunk