Brocade Converged Enhanced Ethernet Command Reference v6.1.2_cee (53-1001217-01, June 2009)

Converged Enhanced Ethernet Command Reference 99
53-1001217-01
debug lacp
6
debug lacp
Enables debugging for the Link Aggregation Control Protocol (LACP).
Synopsis debug lacp {all | cli | event | nsm | pdu {rx {all | interface tengigabitethernet slot/port} | tx {all |
interface tengigabitethernet slot/port} }| sync | timer | trace level number}
no debug lacp {all | cli | event | nsm | pdu {rx {all | interface tengigabitethernet slot/port} | tx { all
| interface tengigabitethernet slot/port} }| sync | timer | trace level number}
Operands all Turns on all debugging.
cli Turns on command line interface debugging.
event Turns on event debugging.
nsm Turns on Nework Services Module (NSM) debugging.
pdu Turns on PDU debugging.
rx all Turns on debugging for received LACP packets on all interfaces.
rx interface Turns on debugging for received LACP packets on the specified
interface.
interface tengigabitethernet
Specifies the 10 Gbps Ethernet interface.
slot Specifies the slot number.
port Specifies the port number.
tx all Turns on debugging for transmitted LACP packets on all interfaces.
tx interface Turns on debugging for transmitted LACP packets on the specified
interface.
interface tengigabitethernet
Specifies the 10 Gbps Ethernet interface.
slot Specifies the slot number.
port Specifies the port number.
sync Turns on debugging for LACP sync transitions.
timer Turns on debugging for LACP timers.
trace level number Specifies the trace level number. The range of valid values is 1-7.
Defaults By default, debugging is not turned on.
Command
Modes
Privileged Exec Mode
Description Use this command to enable debugging for Link Aggregation Control Protocol (LACP). Use the no
debug command to disable debugging.