Fabric OS Message Reference v6.4.0 (53-1001767-01, June 2010)

618 Fabric OS Message Reference
53-1001767-01
SULB-1025
97
SULB-1025
Message <timestamp>, [SULB-1025], <sequence-number>,, WARNING, <system-name>, The blade
in slot <Slot number> will reboot with the new firmware.
Probable Cause Indicates new firmware has been downloaded to the specified AP blade and that the AP blade will
reboot to activate it.
Recommended
Action
Wait for the blade to reboot.
Severity WARNING
SULB-1026
Message <timestamp>, [SULB-1026], <sequence-number>, AUDIT, WARNING, <system-name>,
Firmware commit operation started on the blade in slot <Slot number>.
Probable Cause Indicates the firmwareCommit has started on the specified blade. The operation may be a normal
part of firmwareDownload, or it may have started to repair the secondary partition of the blade if
the secondary partition is corrupted.
Recommended
Action
No action is required.
Severity WARNING
SULB-1030
Message <timestamp>, [SULB-1030], AUDIT, WARNING, <system-name>, The switch has rebooted
during relocating the internal firmware image.
Probable Cause Indicates there may be an error caused by an unexpected disruption of the firmwareDownload
command, for example, by powering the switch off and on in the middle of a firmwareDownload.
The error may also be caused by persistent storage hardware failure or by a software error.
Recommended
Action
The firmwareDownload command will continue after the switch has rebooted. Run the
firmwareDownloadStatus command to monitor progress. If the problem persists, contact your
switch service provider.
Severity WARNING
SULB-1031
Message <timestamp>, [SULB-1031], <sequence-number>, AUDIT, WARNING, <system-name>, The
switch is relocating an internal firmware image.
Probable Cause Indicates the switch has rebooted with the new firmware and is relocating the AP firmware.