Fabric OS Message Reference v6.4.0 (53-1001767-01, June 2010)

Fabric OS Message Reference 487
53-1001767-01
Chapter
83
RCS System Messages
RCS-1001
Message <timestamp>, [RCS-1001], <sequence-number>,, INFO, <system-name>, RCS has been
disabled. Some switches in the fabric do not support this feature.
Probable Cause Indicates that the RCS feature has been disabled on the local switch because not all switches in
the fabric support RCS or the switch is in nonnative mode.
Recommended
Action
Run the rcsInfoShow command to view RCS capability on the fabric. RCS is supported in Fabric OS
v2.6, v3.1 and later, and v4.1 and later.
Run the firmwareDownload command to upgrade the firmware for any switches that do not support
RCS.
Severity INFO
RCS-1002
Message <timestamp>, [RCS-1002], <sequence-number>,, INFO, <system-name>, RCS has been
enabled.
Probable Cause Indicates that the RCS feature has been enabled. RCS must be capable on all switches in the fabric
to be enabled. If all switches are capable, it is automatically enabled.
Recommended
Action
No action is required.
Severity INFO
RCS-1003
Message <timestamp>, [RCS-1003], <sequence-number>,, ERROR, <system-name>, Failed to
allocate memory: (
<function name>)
Probable Cause Indicates that the specified RCS function failed to allocate memory.
Recommended
Action
This message is usually transitory. Wait for a few minutes and retry the command.
Check the memory usage on the switch using the memShow command.
Restart or power cycle the switch.
Severity ERROR