Fabric OS Message Reference v6.4.0 (53-1001767-01, June 2010)

228 Fabric OS Message Reference
53-1001767-01
FCR-1056
34
Severity INFO
FCR-1056
Message <timestamp>, [FCR-1056], <sequence-number>,, INFO, <system-name>, Switch <switch
WWN> with front domain ID <domain ID> does not support backbone to edge imports.
Probable Cause Indicates that a switch that does not support backbone-to-edge routing is running in the MetaSAN.
Recommended
Action
No action is required if backbone-to-edge routing is not needed. Otherwise replace the switch with
one that supports backbone to edge routing.
Severity INFO
FCR-1057
Message <timestamp>, [FCR-1057], <sequence-number>,, ERROR, <system-name>, EX_Port(<port
number>
) incompatible long distance parameters on link.
Probable Cause Indicates that the port, which is configured in long distance mode, has incompatible long distance
parameters.
Recommended
Action
Check the port configuration on both sides of the link using the portCfgShow command.
Investigate the other switch for more details. Run the errShow command on the other switch to
view the error log for additional messages.
Severity ERROR
FCR-1058
Message <timestamp>, [FCR-1058], <sequence-number>,, WARNING, <system-name>, Port <port
number> isolated due to mismatched configuration parameter; <segmentation
reason>.
Probable Cause Indicates that the specified port was isolated after segmentation caused by mismatched
configuration parameters or by domain ID assigned by the principal switch that did not match the
insistent domain ID of this port.
Recommended
Action
Check the switches on both ends of the link for a possible mismatch in switch or port configuration
parameters such as Operating Mode, E_D_TOV, R_A_TOV, Domain ID Offset, etc.
Run the portCfgExport command to modify the appropriate parameters on the local switch.
Run the appropriate configuration command to modify the switch or port parameters on the remote
switch.
Severity WARNING