HP StoreEver 1/8 G2 Tape Autoloader User and Service Guide (AK377-96024, December 2012)

Operator control panel (OCP)
The OCP on the front of the device includes a 2-line by 16-character green backlit liquid crystal
display (LCD), four function keys, and four LEDs. This panel provides everything you need to monitor
the device status and control its functions.
The following functions are available through the OCP:
• “Unlocking the mailslot (Unlock Mailslot)” (page 70)
• “Status/Information” (page 70)
“Inventory (Status/Information > Inventory)” (page 70)◦
◦ “Autoloader information (Status/Information > Autoloader Information)” (page 71)
◦ “Drive information (Status/Information > Drive Information)” (page 72)
◦ “Component status (Status/Information > Component Status)” (page 72)
◦ “Network information (Status/Information > Network Information)” (page 72)
• “Configuration” (page 73)
“Changing the administrator password (Configuration > Change Admin Password)”
(page 73)
◦
◦ “Setting the number of reserved slots (Configuration > Set Reserved Slot Count)” (page 74)
◦ “Configuring the mailslot (Configuration > Configure Mailslot)” (page 74)
◦ “Bar code reporting format (Configuration > Barcode Format Reporting)” (page 74)
◦ “Changing the SCSI address — parallel SCSI devices (Configuration> Change Drive)”
(page 75)
◦ “Setting behaviors (Configuration > Autoloader behavior)” (page 75)
◦ “Setting the date and time (Configuration > Autoloader Date/Time)” (page 76)
◦ “Configuring network settings (Configuration > Configure Network Settings)” (page 76)
◦ “Configuring automatic cleaning (Configuration > Configure Auto Cleaning)” (page 77)
◦ “Restoring factory defaults (Configuration > Restore Defaults)” (page 78)
◦ “Saving and restoring the autoloader configuration (Configuration > Save/Restore
Configuration)” (page 78)
• “Operations” (page 79)
“Unlocking, removing, and replacing magazines (Operations > Unlock Left or Right
Magazine)” (page 79)
◦
◦ “Cleaning the tape drive (Operations> Clean Drive)” (page 80)
◦ “Moving tapes in the Autoloader (Operations > Move Tape)” (page 81)
◦ “Updating tape cartridge inventory (Operations > Perform Inventory)” (page 81)
Operator control panel (OCP) 65