HP StoreEver 1/8 G2 Tape Autoloader User and Service Guide (AK377-96024, December 2012)

Figure 50 Operations: Move Media page
To move a tape, select the source and destination and then click the Move button in the center of
the screen to start the move.
Updating the current media inventory
Use the Operations: Inventory page to have the device re-scan the tapes to update the media
inventory.
Figure 51 Operations: Inventory page
Releasing and replacing the magazines
Use the Operations: Magazine page to release the left, right, or both magazines. When you click
Release, the device will unlock the magazine and display Left Magazine Unlocked or Right Magazine
Unlocked on the OCP screen. If you do not remove the magazine within a few seconds, the device
will lock it. When you replace the magazine, the device will inventory the magazine's tape
cartridges.
Figure 52 Operations: Magazines page
NOTE: To manually release a magazine, see “Releasing the magazines manually” (page 102).
However, this manual process should only be used if the magazine cannot be released using the
OCP or RMI.
60 Operating the tape autoloader