HP StoreEver 1/8 G2 Tape Autoloader User and Service Guide (AK377-96024, December 2012)

Figure 30 Identity: Drive page (parallel SCSI)

Figure 31 Identity: Drive page (SAS)

You can see, but not modify, the following:

• Vendor ID — will always be HP.

• Product ID — product identification information that is given by the drive.

• Serial Number — electronic serial number of the drive. It should match the physical serial

number of the drive.

• Firmware Revision — version of the currently installed drive firmware.

• SCSI ID (parallel SCSI drive only) — SCSI address of the drive. The LUN for the tape drive is

• World Wide ID (SAS drive only) — world wide unique name for the drive. The World Wide

ID is assigned by the autoloader controller to the drive bay and cannot be changed by the

user. When a tape drive is replaced, the World Wide ID is re-assigned to the replacement

drive.

• Physical Drive Slot Number — the physical location of the drive. Will always be 1.

• SCSI Element Address — element address. The SCSI Element Address is set at the factory and

can only be configured by a host application.

Remote management interface (RMI) 41