HP StoreEver 1/8 G2 Tape Autoloader User and Service Guide (AK377-96024, December 2012)

3. Locate the six inscribed foot location lines on the bottom of the autoloader.
4. If the autoloader is not new, clean the foot locations with a damp paper towel.
5. Peel the backing paper off each foot and apply it within a set of foot location lines (see
“Attaching the feet to the bottom of the autoloader” (page 22)).
6. With another person, gently turn the autoloader over and set it on its feet.
Figure 12 Attaching the feet to the bottom of the autoloader
Removing the shipping lock
The shipping lock prevents the robotic transport mechanism from moving during shipment. You
must remove the shipping lock before powering on the device. The shipping lock is held in place
with a piece of tape and is located in the top center of the device. After the shipping lock is
removed, it should be stored on the back panel of the device for future use.
To remove and store the shipping lock:
1. Locate the tape and lock at the top of the device (see “Shipping lock location” (page 22)) .
Figure 13 Shipping lock location
2. Remove the tape, then remove the lock.
22 Installing the autoloader