HP StoreEver 1/8 G2 Tape Autoloader User and Service Guide (AK377-96024, December 2012)

Table 8 Location criteria (continued)
DefinitionCriteria
Do not place the autoloader on its sides or upside down. Do not put anything on top of the
autoloader unless the optional tabletop conversion cover is installed. The tabletop conversion
cover can support up to 15 kg (33 lb).
HP Intelligent Series, HP 5000, HP 10000 Series, HP Rack System/E racks.Rack requirements
1U when mounted in the optional rack railsRack space
requirements
10-35º C (50-95º F)Room temperature
AC power voltage: 100-127 VAC; 200-240 VACPower source
Line frequency: 50-60 Hz
Place the device near an AC outlet. The AC power cord is the product's main AC disconnect
device and must be easily accessible at all times.
11.5 kg (25.4 lb)Weight without media
13.1 kg (28.9 lb)Weight with media
The device should be placed in an area with minimal sources of particulate contamination.
Avoid areas near frequently used doors and walkways, stacks of supplies that collect dust,
printers, and smoke-filled rooms.
Air quality
Excessive dust and debris can damage tapes and tape drives.
20-80 percent relative humidity non-condensingHumidity
Back: Minimum of 15.4 cm (6 inches)Clearance
Front: Minimum of 30.8 cm (12 inches)
Sides: Minimum of 5.08 cm (2 inches)
Unpacking the shipping container
Before you begin, clear a level work surface near where you will place the autoloader.
CAUTION: If the temperature in the room where the device will be installed varies by 15º C (30º
F) from the room where it was stored, allow it to acclimate to the surrounding environment for at
least 12 hours before unpacking it from the shipping container.
Unpacking the tape autoloader:
1. Inspect the container for shipping damage. If you notice any damage, report it to the shipping
company immediately.
2. Open the shipping container and remove the packaging foam and accessories that cover the
device.
3. Lift the device out of the carton, place it on the work surface.
CAUTION: Do not place the autoloader on either end or its sides as this may damage it.
4. Remove any other accessories from the shipping container. Save the packaging materials for
future use.
Identifying product components
Confirm that you received the product components shown in Product components (page 21).
20 Installing the autoloader