HP StoreEver 1/8 G2 Tape Autoloader User and Service Guide (AK377-96024, December 2012)

Table 31 Robotic error sub-codes (continued)
DescriptionSub-code
Elevator
3
movement during check on magazine type failedC2
Sled
5
movement during check on magazine type failedC3
Sled
5
movement to sensor during check on magazine type failedC4
1
Gripper: The part of the robotics assembly that pinches media in order to grip it.
2
Slider: The part of the robotics assembly that plunges in and out for get and put operations.
3
Elevator: The part of the robotics assembly that moves in the vertical direction.
4
Rotation: The part of the robotics assembly that turns the robot to face each magazine and the
drive.
5
Sled: The part of the robotics assembly that moves the robot towards the OCP or back towards
the drive.
Table 32 Device error sub-codes
DescriptionError code
Robotic load not reached Cartridge Present sensor90
No activity after Load command91
Time-out while loading tape92
No activity after load command93
Time-out drive Unload94
Drive terminated unsuccessfully95
Tape not ejected at robot unload96
Slot not free at robot unload97
Cartridge not seated in load phase 198
Drive error codes
Table 33 Drive error codes
DescriptionError code
Drive broken01
Temperature exceeds limit02
Tape error03
Cleaning cartridge is expired04
Drive needs cleaning05
Autoloader lost communication with the drive06
Warning that the tape is nearing its end of life07
120 Troubleshooting