HP StoreEver 1/8 G2 Tape Autoloader User and Service Guide (AK377-96024, December 2012)

Table 30 Main error codes (continued)
Details and solutionDescriptionError code
Elevator
3
reached a position beyond expected
range
95
Rotation
4
reached a position beyond expected
range
96
Sled
5
reached a position beyond expected range97
• Power cycle the device and retry the
operation.
Cartridge present sensor not found98
Slider
2
home sensor not found99
Rotation
4
home sensor not found9A
Sled
5
position sensor not found9B
• Power cycle the device and retry the
operation.
• Remove the magazines and verify that all the
clear plastic inserts in the magazine storage
slots, except the mailslots, are present and
firmly seated.
• Run the wellness test.
Gripper
1
range of motion out of specification9C
• Remove all magazines and look for any
obstructions to the robot.
• Update the firmware to the latest version.
• Run the wellness test.
Slider
2
range of motion out of specification9D
• Remove all magazines and look for any
obstructions to the robot.
Elevator
3
range of motion out of specification9E
• Run the wellness test.
Error codes 111