HP StoreEver 1/8 G2 Tape Autoloader User and Service Guide (AK377-96024, December 2012)

Main error code descriptions
Table 30 Main error codes
Details and solutionDescriptionError code
Power-cycle the unit and retry the operation.Cannot initialize bar code reader80
No response from bar code reader81
• Power-cycle the unit and retry the operation.
• Update the firmware to the latest version.
Power-cycle the unit and retry the operation.No response from EEPROM on robotic controller82
Setting of gripper
1
motor parameters failed84
• Power-cycle the unit and retry the operation.
Setting of slider
2
motor parameters failed85
• Update the firmware to the latest version.
Setting of elevator
3
motor parameters failed86
Setting of rotation
4
motor parameters failed87
Setting of sled
5
motor parameters failed88
108 Troubleshooting