Hitachi Dynamic Link Manager Software Users Guide for Solaris (7.6)

Message
ID
Message Text Explanation
Execute the view operation of the
HDLM command (dlnkmgr view
-path) to check the value
displayed in HDevName. Specify a
host device for the value of
HDevName, and then retry. For
details on the view operation,
seeview (Displays Information)
on page 6-32.
KAPL01019
-W
The target path was not found.
Operation name = aa...aa
Details
aa...aa: offline, online,
monitor, or view
¢
offline/online operation
The specified path does not
exist.
¢
view/monitor operation
The paths have not been
configured because creation
of the HDLM environment or
configuration changes to the
HDLM operating environment
have not finished.
Action
¢
offline/online operation
Use the view operation of the
HDLM command (dlnkmgr) to
check the settings, and then
retry. For details on the view
operation, see
view (Displays
Information) on page 6-32.
¢
view/monitor operation
Refer to Chapter 3, Creating
an HDLM Environment on
page 3-1 or Changing the
Configuration of the HDLM
Operating Environment on
page 4-16, and then
configure any paths that
exist. If the same message
appears again, execute the
DLMgetras utility for
collecting HDLM error
information, acquire the error
information, and then contact
your HDLM vendor or the
company for which you have
a service contract. For details
on the DLMgetras utility, see
The DLMgetras Utility for
Collecting HDLM Error
Information on page 7-3.
8-8
Messages
Hitachi Dynamic Link Manager User Guide for Solaris
®