Hitachi Dynamic Link Manager Software Users Guide for Solaris (7.6)

Figure 4-2 Example of executing the format command
In the above execution example, when you specify an LU, the message
Disk not labeled. Label it now? will be output if a disk label has not
been specified. In this case, enter y and specify a disk label.
3. If setup is performed for Quorum devices and disk device groups, on an
LU newly recognized by the node, release these settings.
When you unregister the SDS or SVM diskset, the diskset data will be
deleted so first back up any necessary data. For details on how to remove
settings for Quorum devices and VxVM disk groups, see
Remove Sun
Cluster Settings on page 3-180 of Preparations for HDLM Removal on
page 3-179. For details on how to remove SDS or SVM disksets, see
Remove SDS Settings on page 3-183 or Remove SVM Settings on page
3-184 of Preparations for HDLM Removal on page 3-179.
4. Make sure that the key used for disk reservation has been registered for
the LU newly recognized by the node.
Execute the following command on any node:
# /usr/cluster/lib/sc/scsi -c inkeys -d the-name-of-the-logical-
device-file-on-slice-2-of-the-LU-newly-recognized-by-the-node
The following shows an example of executing the command:
# /usr/cluster/lib/sc/scsi -c inkeys -d /dev/rdsk/
c3t50060E80033A9902d2s2
4-26
HDLM Operation
Hitachi Dynamic Link Manager User Guide for Solaris
®