Hitachi Dynamic Link Manager Software Users Guide for Solaris (7.6)

This step and the next step set the LU to be used for the post-migration
boot disk as an HDLM-managed LU.
5. Restart the host with the reconfiguration option specified to make the
settings valid and the HDLM device recognizable.
Execute one of the following commands:
¢
# reboot -- -r
¢
boot -r (at the ok prompt)
After you finish these steps, perform the procedure described in
Setting Up
the Post-Migration Environment on page 3-91.
Migration by Installing HDLM in the Existing Local Boot Disk Environment
Perform the steps below in the pre-migration environment. The following
figure shows the workflow.
Creating an HDLM Environment
3-85
Hitachi Dynamic Link Manager User Guide for Solaris
®