Hitachi Dynamic Link Manager Software Users Guide for Linux (6.6) (HIT5203-96005, November 2011)

15. Make sure that the SCSI device is used by the file system and the swap
partition.
Make sure of the following three things: that the root directory is
associated with the SCSI device, that the SCSI device is mounted, and
that the SCSI device is assigned to the swap partition.
¢
When the boot loader is LILO or GRUB
Figure 3-44 Example of Executing the mount Command When the
Boot Loader Is LILO or GRUB on page 3-224
shows an example of
executing the mount command.
Figure 3-44 Example of Executing the mount Command
When the Boot Loader Is LILO or GRUB
¢
When the boot loader is ELILO running on an IPF host
Figure 3-45 Example of Executing the mount Command When the
Boot Loader Is ELILO on page 3-224
shows an example of executing
the mount command.
Figure 3-45 Example of Executing the mount Command
When the Boot Loader Is ELILO
Refer to the /proc/swaps
file to make sure that the specified SCSI device
name is displayed in the Filename column.
Go to step 18.
16. Update the information about the volume group.
Execute the following command to update the information about the
volume group.
# vgscan
Reading all physical volumes. This may take a while...
Found volume group "VolGroup00" using metadata type lvm2
17. Check the relationship between the volume group and HDLM devices.
3-224
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Linux(R))