Hitachi Dynamic Link Manager Software Users Guide for Linux (6.6) (HIT5203-96005, November 2011)

Xen Hypervisor Operating Environments Supported by HDLM on page
3-67.
:
:
title XEN
root (hd0,1)
kernel /boot/xen.gz
module /boot/vmlinuz-2.6.16.60-0.21-xen
root=/dev/disk/by-id/
scsi-1HITACHI_D60H03750027-part2 vga=0x31a resume=/dev/sda1
splash=silent showopts
module /boot/initrd-2.6.16.60-0.21-xen
If LABEL or the device name (udev name) was not used in step 3 and step
4, proceed to step 17 and install a new instance of HDLM.
If the device name (udev
name) has been specified, replace LABEL with
the device name (udev name) when reading the steps below.
5. Execute the mount command to check the mounted file system.
Check the correspondence between the SCSI device and LABEL that you
checked in steps 3 and 4. You will need this information to remove the
LABEL setting.
# mount
/dev/sda2 on / type ext2 (rw)
:
:
/dev/sda1 on /boot type ext2 (rw)
/dev/sda4 on /tmp type ext2 (rw)
/dev/sda5 on /var type ext2 (rw)
/dev/sda6 on /usr type ext2 (rw)
none on /dev/shm type tmpfs (rw)
Check the underlined section.
6. If Red Hat Enterprise Linux, SUSE LINUX Enterprise Server 10, or SUSE
LINUX Enterprise Server 11 is being used, check the SCSI device name in
the /proc/swaps file.
The SCSI device name is displayed in the Filename
column.
7. If the block device name or the udev name was specified in steps 3 and 4,
execute the following commands to check the SCSI device:
¢
For Red Hat Enterprise Linux 6
Execute the udevadm command. Specify the block device name for –n.
# udevadm info --query name –n /dev/disk/by-uuid/
55574d05-07dc-4c94-a585-5599c284d79b
sda2
The sda2 value output is the SCSI device name corresponding to
55574d05-07dc-4c94-a585-5599c284d79b.
¢
For SUSE LINUX Enterprise Server 10 or SUSE LINUX Enterprise
Server 11
Creating an HDLM Environment
3-109
Hitachi Dynamic Link Manager User Guide (for Linux(R))