Hitachi Dynamic Link Manager Software Users Guide for Solaris (7.6)

2. Get Solaris to recognize the LUs to be used by the post-migration boot
disk.
3. Set the LU slices to be used by the post-migration boot disk.
4. Complete the preparations for installing HDLM in the pre-migration
environment and then install HDLM, referring to the description in
Installing HDLM on page 3-45.
Perform the necessary steps.
Note
Note the following when you set the devices to be excluded at step 11
of
Performing a New Installation of HDLM (When Sun Cluster Is Not
Being Used) on page 3-55 or in step 17 of Performing a New
Installation of HDLM (When Sun Cluster Is Being Used) on page 3-62:
- If the boot disk in the pre-migration environment is an HDLM-
managed device, change the setting to exclude it from HDLM
management.
- Set the post-migration boot disk as an HDLM-managed device.
After you finish these steps, perform the procedure described in Setting Up
the Post-Migration Environment on page 3-91.
Migration by Building a New Pre-Migration Environment
Perform the following steps in the pre-migration environment. The following
figure shows the workflow.
Creating an HDLM Environment
3-89
Hitachi Dynamic Link Manager User Guide for Solaris
®