Hitachi Dynamic Link Manager Software Users Guide for Solaris (7.6)

3. Set the LU slices to be used by the post-migration boot disk.
4. Complete the preparations for installing HDLM in the pre-migration
environment and then install HDLM, referring to the description in
Installing HDLM on page 3-45.
Perform the necessary steps.
Note
Do not exclude the post-migration boot disk from HDLM management
when you set the devices to be excluded in step 11 of Performing a
New Installation of HDLM (When Sun Cluster Is Not Being Used) on
page 3-55 or in step 17 of Performing a New Installation of HDLM
(When Sun Cluster Is Being Used) on page 3-62.
After you finish these steps, perform the procedure described in Setting
Up the Post-Migration Environment on page 3-91.
Migration by Installing HDLM in the Existing Boot Disk Environment
Perform the following steps in the pre-migration environment. The following
figure shows the workflow.
Creating an HDLM Environment
3-87
Hitachi Dynamic Link Manager User Guide for Solaris
®