Hitachi Dynamic Link Manager Software Users Guide for Linux (6.6) (HIT5203-96005, November 2011)

Execute the following command and make sure that 0
is displayed for
Used for sddlmfdrv:
# /sbin/lsmod
Module Size Used by
:
:
sddlmfdrv 254092 0
If a value other than 0 is displayed for Used, perform the operation
described in
Operations on HDLM-Managed Devices on page 3-199, and
then perform steps 2 and 3 in Uninstalling HDLM on page 3-217
so that
the HDLM devices can no longer be used.
21. Uninstall HDLM.
To uninstall HDLM, execute the following command:
# rpm -e HDLM
22. Make sure that the uninstallation has been completed.
You must execute the following command to make sure that the
uninstallation has been completed. The following information is output.
# rpm -qi HDLM
package HDLM is not installed
Uninstalling Hitachi Network Objectplaza Trace Library (HNTRLib2)
When you uninstall HDLM, if the KAPL09019-E or KAPL09020-E message is
output, follow the directions below to uninstall HNTRLib2.
To uninstall HNTRLib2:
1. Log in to Linux as the root user.
2. Execute the following command to unregister the name of the bundled
program products.
# /opt/hitachi/HNTRLib2/etc/hntr2cancel "Hitachi Dynamic Link
Manager"
3. Execute the following command.
# /opt/hitachi/HNTRLib2/etc/hntr2setup
The HNTRLib2 setup menu will appear.
4. From the Setup menu, select 9.
HNTRLib2 will be uninstalled.
If HNTRLib2 is not being used by any other programs:
HNTRLib2 will be uninstalled normally, and the following message will
appear.
3-226
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Linux(R))