Hitachi Dynamic Link Manager Software Users Guide for Linux (6.6) (HIT5203-96005, November 2011)

Table 3-60 Values Indicating Audit Log Data Collection Levels on page 3-191
describes the values that indicate audit log data collection levels. An audit log
data collection level is a severity level. The default is 6.
Table 3-60 Values Indicating Audit Log Data Collection Levels
Value (severity) Explanation
0 No audit log data is collected.
1
2 Critical-level audit log data is collected.
3 Critical-level and Error-level audit log data is collected.
4 Critical-level, Error-level, and Warning-level audit log data is
collected.
5
6 Critical-level, Error-level, Warning-level, and Informational-level
audit log data is collected.
7
Table 3-61 Values Indicating Audit Log Data Categories on page 3-191
describes the values that indicate audit log data categories. The default is
all.
Table 3-61 Values Indicating Audit Log Data Categories
Value Explanation
ss
Audit log events of the StartStop
category are collected.
a
Audit log events of the Authentication category are collected.
ca
Audit log events of the ConfigurationAccess
category are collected.
all
Audit log events of the StartStop, Authentication, and
ConfigurationAccess
categories are all collected.
This example shows how to enable the collection of audit log data:
# /opt/DynamicLinkManager/bin/dlnkmgr set -audlog on -audlv 6 -
category all
Specify on
if you want to collect audit log data, and off if you do not want to
collect audit log data. If you specify on, you can use the -audlv parameter to
specify the collection level for audit log data and the -category parameter to
specify the audit log categories.
If you want to set the audit log facility, see
Setting the Audit Log Facility on
page 3-191.
Setting the Audit Log Facility
The following describes how to specify the output destination for audit log
data.
Creating an HDLM Environment
3-191
Hitachi Dynamic Link Manager User Guide (for Linux(R))