User Manual Part 1

Perform a Hard Reset
A hard reset stops all running applications, but does not erase any programs or saved data. A hard reset
also resets all hardware registers. Be sure to save any unsaved data within a running application before
performing a hard reset.
NOTE: You can also use these steps to perform a soft reset.
To perform a hard reset:
1. Locate the recessed Reset button at the top of your HP iPAQ.
2. Use the stylus to lightly press the Reset button.
3. Release the Reset button.
The HP iPAQ resets and powers on.
Perform a Factory Reset
A factory reset clears all user-installed settings, programs, and data, and it restores your HP iPAQ to
factory settings.
To perform a factory reset:
1. Turn off your HP iPAQ.
2. Press the ok button located on the right side of the unit and the Voice Commander button located
on the left side of the unit.
3. Keeping the ok and the Voice Commander buttons pressed, use the stylus to lightly press the
Reset button.
4. Release the Reset button.
5. Release the ok button and the Voice Commander button when Clean Boot is displayed on the
screen.
NOTE: You can also tap Start > Settings > System > Factory Recovery, and then follow the
on-screen instructions.
Reset your HP iPAQ 39