Owners manual
Table Of Contents
- The basics
- The control panel
- Printing
- Overview
- Orienting media
- Basic printing instructions
- Selecting the output bin
- Printing on envelopes
- Printing on special paper
- Printing on both sides of paper (duplexing)
- Using features in the printer driver
- Setting the registration
- Different first page
- Including a blank back page
- Printing multiple pages on one sheet of paper
- Customizing Tray 1 operation
- Specifying paper to print on
- Job storage features
- Printing a private job
- Releasing private jobs
- Deleting a private job
- Storing a print job
- Printing a stored job
- Deleting a stored job
- Creating a QuickCopying job
- Printing additional copies of QuickCopy jobs
- Deleting a QuickCopy job
- Proofing and holding a job
- Printing the remaining copies of a held job
- Deleting a held job
- Copying
- Faxing
- Output devices
- Security features
- MFP maintenance
- Problem solving
- Specifications
- Control panel menus
- MFP memory and expansion
- Regulatory information
- Administration tasks
- Using the HTML Help Viewer
- Using accessibility shortcut keys in the Help Viewer
- Index
ENWW Loading input trays 39
8 Note the orientation of the paper, as well as the value of the X dimension and the Y
dimension. The X and Y dimensions are marked in the tray. You will need this information for
a later step.
Note When loading Tray 4, make sure that the paper guide lock is in the up position.
9 Close the tray.
10 Look at the control panel within a few seconds of closing the tray. (Open and close the tray if
the time has already elapsed.) The control panel displays the tray size and type
configuration.
• If the size and type settings are correct, touch EXIT to accept the settings. The tray is
ready to use. (You do not need to complete the rest of this procedure unless you want to
configure the exact custom dimension. See the following note for more information.)
• To change the size setting, touch OK. The TRAY N SIZE=*<SIZE> menu is displayed.
Note If the size displayed on the control panel is CUSTOM, then the tray size is set to ANY CUSTOM. The
tray will match any custom-size print job, even if the print-job dimensions are different from the
dimensions of the paper that is loaded in the tray. If you prefer, you can specify the exact
dimensions of the custom-size paper that is loaded in the tray. When you specify exact dimensions,
the dimensions are displayed as the size, rather than CUSTOM.
11 Touch CUSTOM. The UNIT OF MEASURE menu is displayed.
Note The MFP might prompt you to move the Custom/Standard switch in the tray to another position.
The MFP might also prompt you to move the paper guides. Follow the instructions on the control
panel, close the tray, and then repeat this procedure starting with step 10.
12 Touch unit of measure (MILLIMETERS or INCHES). (If you are using the measurement on the
tray guide, select MILLIMETERS.)
13 Use the numeric keypad to select the X (front to back) dimension.
14 Touch OK.
15 Use the numeric keypad to select the Y (left to right) dimension.
16 Touch OK. The control panel displays SETTING SAVED for a moment. The tray size in
dimensions is then displayed.
17 Touch EXIT to accept the settings. The tray is ready to use.