Owners manual
Table Of Contents
- The basics
- The control panel
- Printing
- Overview
- Orienting media
- Basic printing instructions
- Selecting the output bin
- Printing on envelopes
- Printing on special paper
- Printing on both sides of paper (duplexing)
- Using features in the printer driver
- Setting the registration
- Different first page
- Including a blank back page
- Printing multiple pages on one sheet of paper
- Customizing Tray 1 operation
- Specifying paper to print on
- Job storage features
- Printing a private job
- Releasing private jobs
- Deleting a private job
- Storing a print job
- Printing a stored job
- Deleting a stored job
- Creating a QuickCopying job
- Printing additional copies of QuickCopy jobs
- Deleting a QuickCopy job
- Proofing and holding a job
- Printing the remaining copies of a held job
- Deleting a held job
- Copying
- Faxing
- Output devices
- Security features
- MFP maintenance
- Problem solving
- Specifications
- Control panel menus
- MFP memory and expansion
- Regulatory information
- Administration tasks
- Using the HTML Help Viewer
- Using accessibility shortcut keys in the Help Viewer
- Index
ENWW Loading input trays 37
9 Look at the control panel within a few seconds of closing the tray. (Open and close the tray if
the time has already elapsed.) The control panel displays the tray size and type settings. Do
one of the following:
• If the size and type settings are correct, touch EXIT to accept the settings.
• If the size and type settings are not correct, touch OK. The TRAY N SIZE=*<SIZE> menu is
displayed.
10 To change the size setting, touch the correct paper size. The message SETTING SAVED is
displayed for a moment, and then the tray type menu is displayed.
Note Depending on the size that you selected, the MFP might prompt you to move the Custom/Standard
switch in the tray to another position. The MFP might also prompt you to move the paper guides.
Follow the instructions on the control panel, close the tray, and then repeat this procedure starting
with step 9.
11 To change the type setting, Touch the correct paper type. The message SETTING SAVED is
displayed for a moment, and then the size and type settings are displayed.
12 If the size and type settings are correct, touch EXIT to accept the settings. The tray is ready
to use.
Loading custom media in Trays 2, 3, and 4
Use the following procedure to load custom-size paper in the tray.
CAUTION To avoid a jam, never add or remove paper from a tray while printing from that tray.
1 Open the tray until it stops.
2 Press the tab on the front (X) paper guide and slide the guide all the way out.
3 Press the tab on the left (Y) paper guide and slide the guide all the way out.