Owners manual
Table Of Contents
- The basics
- The control panel
- Printing
- Overview
- Orienting media
- Basic printing instructions
- Selecting the output bin
- Printing on envelopes
- Printing on special paper
- Printing on both sides of paper (duplexing)
- Using features in the printer driver
- Setting the registration
- Different first page
- Including a blank back page
- Printing multiple pages on one sheet of paper
- Customizing Tray 1 operation
- Specifying paper to print on
- Job storage features
- Printing a private job
- Releasing private jobs
- Deleting a private job
- Storing a print job
- Printing a stored job
- Deleting a stored job
- Creating a QuickCopying job
- Printing additional copies of QuickCopy jobs
- Deleting a QuickCopy job
- Proofing and holding a job
- Printing the remaining copies of a held job
- Deleting a held job
- Copying
- Faxing
- Output devices
- Security features
- MFP maintenance
- Problem solving
- Specifications
- Control panel menus
- MFP memory and expansion
- Regulatory information
- Administration tasks
- Using the HTML Help Viewer
- Using accessibility shortcut keys in the Help Viewer
- Index
218 Appendix C MFP memory and expansion ENWW
5 Press the compact flash straight into the slot.
CAUTION Do not insert the flash memory card at an angle.
Note The first flash memory slot marked “Firmware Slot” is reserved for firmware only. Slots 2 and 3
should be used for all other solutions.
6 Slide the formatter board back into the MFP and tighten the two screws.
7 Plug in the power cord and connect all cables. Turn the MFP on.