Owners manual
Table Of Contents
- The basics
- The control panel
- Printing
- Overview
- Orienting media
- Basic printing instructions
- Selecting the output bin
- Printing on envelopes
- Printing on special paper
- Printing on both sides of paper (duplexing)
- Using features in the printer driver
- Setting the registration
- Different first page
- Including a blank back page
- Printing multiple pages on one sheet of paper
- Customizing Tray 1 operation
- Specifying paper to print on
- Job storage features
- Printing a private job
- Releasing private jobs
- Deleting a private job
- Storing a print job
- Printing a stored job
- Deleting a stored job
- Creating a QuickCopying job
- Printing additional copies of QuickCopy jobs
- Deleting a QuickCopy job
- Proofing and holding a job
- Printing the remaining copies of a held job
- Deleting a held job
- Copying
- Faxing
- Output devices
- Security features
- MFP maintenance
- Problem solving
- Specifications
- Control panel menus
- MFP memory and expansion
- Regulatory information
- Administration tasks
- Using the HTML Help Viewer
- Using accessibility shortcut keys in the Help Viewer
- Index

ENWW Installing memory 215
3 Loosen the two captive thumb screws on the back of the MFP.
4 Grasp the screws and pull the formatter board out of the MFP. Place it on a flat,
non-conductive surface.
5 Remove the DIMM from the antistatic package. Hold the DIMM with fingers against the side
edges and thumbs against the back edge. Align the notches on the DIMM with the DIMM
slot. (Check that the locks on each side of the DIMM slot are open, or outward.)
Note See Installing memory for the maximum amount of memory for each DIMM slot.