Owners manual
Table Of Contents
- The basics
- The control panel
- Printing
- Overview
- Orienting media
- Basic printing instructions
- Selecting the output bin
- Printing on envelopes
- Printing on special paper
- Printing on both sides of paper (duplexing)
- Using features in the printer driver
- Setting the registration
- Different first page
- Including a blank back page
- Printing multiple pages on one sheet of paper
- Customizing Tray 1 operation
- Specifying paper to print on
- Job storage features
- Printing a private job
- Releasing private jobs
- Deleting a private job
- Storing a print job
- Printing a stored job
- Deleting a stored job
- Creating a QuickCopying job
- Printing additional copies of QuickCopy jobs
- Deleting a QuickCopy job
- Proofing and holding a job
- Printing the remaining copies of a held job
- Deleting a held job
- Copying
- Faxing
- Output devices
- Security features
- MFP maintenance
- Problem solving
- Specifications
- Control panel menus
- MFP memory and expansion
- Regulatory information
- Administration tasks
- Using the HTML Help Viewer
- Using accessibility shortcut keys in the Help Viewer
- Index
ENWW Checking the MFP configuration 175
Usage page
Use the usage page to obtain information about the page sizes and number of pages printed,
copied, and sent.
The usage page contains the following information:
1 Product Name and Device name indicate the series of HP LaserJet MFP in use.
2 Usage Totals indicates types of pages that have been printed, copied, and scanned; the
number of single-sided pages printed, copied and scanned; the number of duplexed pages
printed, copied and scanned; and the total number of pages printed, copied and scanned.
3Coverage indicates the average amount of toner used on all pages printed.
PCL or PS font list
Use the font lists to see which fonts are currently installed in the MFP. (The font lists also show
which fonts are resident on a hard disk or flash DIMM.)
The PS font list shows the PS fonts installed, and gives a sample of those fonts. The following
describes the information that can be found on the PCL font list:
● Font gives the font names and samples.
● Pitch/Point indicates the pitch and point size of the font.
● Escape Sequence (a PCL 5e programming command) is used to select the designated font.
(See the legend at the bottom of the font list page.)
● Font # is the number used to select fonts from the control panel (not the software
application). Do not confuse the font # with the font ID (see the following information). The
number indicates the DIMM slot where the font is stored.
• SOFT: Downloaded fonts that stay resident in the MFP until other fonts are downloaded to
replace them or until the MFP is turned off.
• INTERNAL: Fonts that permanently reside in the MFP.
● Font ID is the number you assign to soft fonts when you download them through software.
1
HP LaserJet 9050mfp series
Usage Page (S/N XXXXXXXXXX)
1
2
3