Owners manual

ENWW 49
3. Press ✔ to select CONFIGURE DEVICE.
4. Press  to highlight I/O.
5. Press ✔ to select I/O.
6. Press  to highlight EIO X (where X = 1, 2, or 3).
7. Press ✔ to select EIO X.
8. Press  to highlight AUTO.
9. Press ✔ to select AUTO.
10. Press the P
AUSE/RESUME button to return to the READY state.
To manually configure TCP/IP parameters from the
printer control panel
Use manual configuration to set an IP address, subnet mask, and
local and default gateway.
Setting an IP address
1. Press ✔ to enter the MENUS.
2. Press  to highlight CONFIGURE DEVICE.
3. Press ✔ to select CONFIGURE DEVICE.
4. Press  to highlight I/O.
5. Press ✔ to select I/O.
6. Press  to highlight EIO X (where X = 1, 2, or 3).
7. Press ✔ to select EIO X.
8. Press  to highlight MANUAL.
9. Press ✔ to select MANUAL.
10. Press  to highlight IP ADDRESS.
11. Press ✔ to select IP ADDRESS.
Note The first of three sets of numbers is highlighted. If there is not a number
highlighted, a highlighted empty underscore appears.
12. Press the  or  arrow to to increase or decrease the number
for configuring the IP address.
13. Press ✔ to move to the next set of numbers.
14. Repeat steps 12 and 13 until the correct IP address is entered.
15. Press the P
AUSE/RESUME button to return to the READY state.