User's Manual

Use the HP sp400 Series Configuration Software
Network tab
The Network tab allows you to configure the All-in-One so it can gain access to a wireless network.
IP Address
The IP Address section is where you make choices about how the All-in-One will connect wirelessly.
• Enable DHCP check box: Select this box to enable the Dynamic Host Configuration Protocol
(DHCP). A DHCP server on your network is required to use this option. Contact your network
administrator to determine if your Wi-Fi network has a DHCP server.
• DHCP Time Out (seconds): The number of seconds the All-in-One will spend attempting to locate
a DHCP server.
The following fields are enabled only if the Enable DHCP check box is not selected. Contact your
network administrator for the correct values.
• Static IP
• Subnet Mask
• Default Gateway
• Primary DNS
• Secondary DNS
Wireless Network Type
• Access Point: Select Access Point if the All-in-One will communicate with the server through an
access point.
• Ad Hoc: Select Ad Hoc if the All-in-One will communicate with the server application directly (not
through an access point).
14