User's Manual

Use the HP sp400 Series Configuration Software

Timeouts & Limits tab

The Timeouts & Limits tab allows you to set various timeouts and limits that affect the function of the All-

in-One.

Device Timeouts

The Device Timeouts section allows you to change the length of eight different timeouts and intervals.

• Registration Retry Interval (s): The number of seconds that the All-in-One pauses between

registration messages. These messages are sent from the All-in-One device to the server.

• SPP Ack Timeout (ms): The number of milliseconds the All-in-One waits for a response from the

server before resending a message.

• Heartbeat Interval (ms): The length of time in milliseconds between the heartbeat messages that

are sent from the All-in-One to the server.

• Retrigger Delay After Print (ms): The length of time in milliseconds the All-in-One pauses after a

successful print has been made before it is ready to scan again.

• Print Incomplete Timeout (ms): The length of time in milliseconds which the user has available to

make a successful print after print data has been received from the server.

Battery

The Battery section allows you to adjust the point at which the battery low (LED and audio) warnings will

be activated.

• Battery Low Warning (%): The percentage of battery life that is still available when the All-in-One

activates the Battery Low warning.

• Battery Very Low Warning (%): The percentage of battery life that is still available when the

All-in-One activates the Battery Very Low warning.

If the Disable Audio check box is selected, the audio warning will not sound when the battery is low or

very low.