User's Manual

Using the HP sp400 Series Template Design Software
Use the default print templates
The All-in-One comes from the factory with four default print templates installed on it.
There are three non-wireless templates for use in Demonstration mode (where a wireless connection is
not used):
○ System Information print template
○ sp400 Demonstration print template
○ Pen Diagnostic print template
There is one wireless print template (for use with a wireless connection):
○ sp400 Default (wireless) print template
To turn the All-in-One on in Demonstration mode, press the
CLEAR button while pressing the Power
button.
To select the default print templates on the All-in-One while in Demonstration mode, press the
CLEAR
button. You will hear one Hi tone when the system information template is selected, two when the
sp400 Demonstration template is selected, and three when the Pen Diagnostic template is selected,
and so on. Scan a barcode to print the selected print template.
The All-in-One can save up to seven user-defined demonstration print templates if sufficient memory is
available on the All-in-One.
The System Information print template and the Pen Diagnostic print template contain information that is
useful to service technicians when problems arise.
10
Figure 3-2. System Information print template
6
2
1
3
4
5
1 FW version
2 Ink remaining % (estimate)
3 Serial number
4 Image count on print cartridge
5 Image count since power turned on
6 Battery level %