User's Manual

Configuration
Configuring the High Availability Feature for X.25 over LLC2
Chapter 3 87
Figure 3-14 After the Failover
To configure XOL local failover, complete the following steps:
Step 1. To enable the XOL HA feature for the system, run the following
command:
x25init -enableXOLHA
NOTE Enabling or disabling of HA feature for XOL interface is system wide.
Before enabling or disabling the HA feature on a system, all existing
XOL interfaces must be stopped.
Step 2. To configure the standby device and the unique MAC address in the
configuration file of the XOL primary interface, modify the following
syntax:
Standby_device <standby LAN card name> # used for local
failover