User's Manual

Configuration
Configuring X.25 over LLC2
Chapter 364
<Ctrl+Z>
• To add routing entries to X.25 routing table, complete the following
steps:
Step 1. Run the following command at the CISCO console:
Configure Terminal
Step 2. Run the following command at the CISCO console:
x25 route ^ 7111 interface FastEthernet1/10 mac
0011.0a80.31d6
Step 3. Run the following command at the CISCO console:
x25 route ^ 7222 interface FastEthernet1/10 mac
0800.09c4.728a
Step 4. Run the following command at the CISCO console:
<Ctrl+Z>
Starting and Stopping Configuration
Starting
To initialize the x25overllc2 devices, execute the x25init command with
the -L option at the command prompt.
The syntax for execution is:
x25init -c <config_file> -L <llc2_config_file>
config_file is the generic X.25 product configuration file and
llc2_config_file is the LLC2 specific configuration file.
A sample invocation is as shown below:
x25init -c x25init_def -L llc2_conf_def
This command is executed once per box. It can be executed with different
<x25init_llc2_sampl> file but with the same <llc2_conf_def> file.
Stopping
To stop the communication with one box, the x25stop command is
executed with the -L option.The syntax for execution is:
x25stop -d <lan#> -L <XOL_logical_port_id>