User's Manual

Configuration
Configuring X.25 over LLC2
Chapter 3 63
neg_inthruputclass 19200 # offered thruput class if using thruput class
negotiation
neg_outthruputclass 19200 # offered thruput class if using thruput class
negotiation
pvc_inpacketsize 128 # packetsize for PVCs
pvc_outpacketsize 128 # packetsize for PVCs
pvc_inwindow 7 # window size for PVCs
pvc_outwindow 7 # window size for PVCs
# IP Related Parameters
IP 15.4.64.120 255.255.248.0 # IP address and subnet mask
mtu 1024 # max transmission unit 1024 octets
hold 300 # 5 minute hold timer
idle 600 # 10 minute idle timer
NOTE For an XOL configuration, L3 packet sizes greater than 1024 are not
supported.
If the XOL interface on the host is connected to a router supporting X.25
over LLC2, the router must be configured with the correct routing
entries. For example, if an XOL interface on the host is connected to a
CISCO router and the XOL configuration on the host is identical to the
configuration in the previous example, the following configuration is
required:
• To enable the cmns, complete the following steps:
Step 1. Run the following command at the CISCO console:
Configure Terminal
Step 2. Run the following command at the CISCO console:
Interface fastethernet 1/0
Step 3. Run the following command at the CISCO console:
cmns enable
Step 4. Run the following command at the CISCO console: