User's Manual

Configuration
Configuring Remote System Access
Chapter 3 51
Configuring Remote System Access
Follow the steps below to configure access to other hosts and systems
that use TCP/IP protocol. (The procedures in this section are optional.
Your X.25 link software does not require that you configure access to
other systems).
Step 1. If you have not already done so, type sam at the HP-UX prompt.
Step 2. At the SAM main window, highlight Networking and Communications
and click on OPEN.
Step 3. At the “Networking and Communications” window, highlight Hosts and
click on OPEN. Highlight Local Hosts and click on OPEN.
SAM displays all remote system names and IP addresses that have
already been configured.
Step 4. Select Add from the Actions menu. The following dialog appears:
NOTE The appearance of the “Add Internet Connectivity” dialog may be slightly
different from the example below depending on the version of the X.25
software you are running.