User's Manual

Configuration
Configuring the X.25 Link
Chapter 334
Configuring an X.25 Address
Follow the steps below to configure an X.25 address:
Step 1. From the “Configure X.25 Software” window, select Configure X.25
Address. The following dialog appears:
Figure 3-1
NOTE The SAM windows and dialogs shown on these pages are intended only
as examples. The information that appears in your SAM dialogs, such as
the Card Name and Programmatic Access Name, depends on your
particular communications hardware.
Step 2. Enter or modify the field values as required (refer to the field
descriptions below).