Operation Manual

Software and configuration utilities
BIOS Setup Utility
Use the embedded BIOS setup utility to perform a wide range of configuration activities including:
• Configuring system devices and installed options
• Displaying system information
• Selecting the primary boot controller
• Configuring memory options
Boot options
Near the end of the boot process, the boot options screen is displayed. This screen is visible for several
seconds before the system attempts to boot from a supported boot device. During this time, you can do
the following:
• Access BIOS Setup Utility by pressing the Esc/Delete key.
• Access Boot screen by pressing the F7 key.
• Force a PXE Network boot by pressing the F12 key.
Re-entering the server serial number and product ID
After replacing the system board, you must re-enter the server serial number and product ID.
Procedure
1. To enable SPD Write:
a. During the server startup sequence, press the Delete or Esc key to access the BIOS Setup menu.
b. Select Chipset > PCH-IO Configuration, and then press the Enter key.
c. Select SPD Write Disable and press Enter.
d. To enable SPD Write, select Disable and press Enter.
e. To exit Chipset, press the Esc key.
f. Select Save & Exit > Save Changes and Exit, and press Enter.
g. To save changes, select Yes. The server automatically reboots.
2. To enter the product ID:
a. During the server startup sequence, press the Delete or Esc key to access the BIOS Setup menu.
b. Select Advanced > System FRU Information, and then press the Enter key.
c. Select FRU update Support and press Enter.
d. Select Enable and press Enter.
e. Select Modify Product Part/Model Number and press Enter.
Enter the Modify Product Part/Model Number and press Enter.
f. Select Modify Product S/N and press Enter.
Enter the Modify Product S/N and press Enter.
g. Select Start Update FRU and press Enter.
h. Select Enable and press Enter. The following warning appears:
If you enable this item, the data will be written in FRU.
i. To clear the warning, press Enter. The following message appears:
FRU has been updated. Please reboot and check it.
j. To clear the message, press Enter. The following warning appears:
Please enable the setting of SPD Write Disable for security.
Software and configuration utilities 47