Operation Manual

11. To connect the SATA cables:
a. Connect drive 1 to SATA 1 on the system board.
b. Connect drive 2 to SATA 2 on the system board.
c. Connect drive 3 to SATA 3 on the system board.
d. Connect drive 4 to SATA 4 on the system board.
e. Connect drive 5 to SATA 5 on the system board.
12. Install the tower bezel.
13. Install the access panel.
14. Return the server to an upright position.
15. Connect each power cord to the server.
16. Connect each power cord to the power source.
17. Power up the server.
24 Hardware options installation