Operation Manual

a. Place the access panel on the chassis, and slide it toward the front of the server.
b. Tighten the two screws on the access panel.
2. If a Kensington security cable was removed, connect it to the rear panel. See the security cable
documentation for instructions.
Remove the tower bezel
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove the access panel.
4. Remove all USB devices from the front I/O assembly.
5. Open the tower bezel.
14 Remove the tower bezel