Operation Manual

CAUTION:
For proper cooling, do not operate the server without the access panel, baffles, expansion slot
covers, or blanks installed. If the server supports hot-plug components, minimize the amount of time
the access panel is open.
CAUTION:
To prevent damage to electrical components, take the appropriate anti-static precautions before
beginning any installation, removal, or replacement procedure. Improper grounding can cause
electrostatic discharge.
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. If a Kensington security cable is installed, disconnect it from the rear panel. See the security cable
documentation for instructions.
4. Remove the access panel:
a. Loosen the access panel screws.
b. Slide the access panel back.
c. Lift the access panel away from the chassis.
Install the access panel
Procedure
1. Install the access panel:
Install the access panel 13