HP Compaq 8510w Mobile Workstation and HP Compaq 8510p Notebook PC - Maintenance and Service Guide

Remove the battery (see

Battery on page 47).

5. Remove the following components:

Keyboard (see

Keyboard on page 58)

b. Fan (see

Fan on page 63)

c. Heat sink (see

Heat sink on page 64)

Remove the graphics card:

1. Remove the two Phillips PM2.0×3.0 screws (1) that secure the graphics card to the computer. (The

edge of the board opposite the graphics card slot rises away from the computer.)

2. Remove the graphics card (2) by sliding it away from the graphics card slot at an angle.

NOTE: The graphics card is designed with a notch (3) to prevent incorrect installation.

Reverse this procedure to install the graphics card.

Component replacement procedures