HP Compaq 8510w Mobile Workstation and HP Compaq 8510p Notebook PC - Maintenance and Service Guide
4.
Remove the battery (see
Battery on page 47).
5. Remove the following components:
a.
Hard drive (see
Hard drive on page 51)
b. Optical drive (see
Optical drive on page 54)
c. Keyboard (see
Keyboard on page 58)
d. Fan (see
Fan on page 63)
e. Heat sink (see
Heat sink on page 64)
f. Switch cover (see
Switch cover on page 75)
g. TouchPad (see
TouchPad on page 70)
h.
Display assembly (see
Display assembly on page 79)
i. Top cover (see
Top cover on page 84)
j.
Speaker assembly (see
Speaker assembly on page 87)
k. Modem module (see
Modem module on page 89)
l. System board (see
System board and system board frame on page 90)
Remove the PC Card assembly:
1. Turn the system board upside down, with the front toward you.
2. Remove the two Phillips PM2.0×3.0 screws that secure the PC Card assembly to the system board.
3. Detach the slots on the PC Card assembly from the tabs on the PC Card connector (1).
96 Chapter 4 Removal and replacement procedures