HP Compaq 8510w Mobile Workstation and HP Compaq 8510p Notebook PC - Maintenance and Service Guide

Speaker assembly (see

Speaker assembly on page 87)

k. Modem module (see

Modem module on page 89)

System board (see

System board and system board frame on page 90)

Remove the RJ-11 connector cable:

1. Remove the RJ-11 connector (1) from the clip built into the base enclosure.

2. Remove the RJ-11 connector cable from the clips and routing channel (2) built into the base

enclosure.

3. Remove the RJ-11 connector cable from the base enclosure.

Reverse this procedure to install the RJ-11 connector cable.

PC Card assembly

Description Spare part number

PC Card assembly 455893-001

Before removing the PC Card assembly, follow these steps:

1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the

computer on, and then shut it down through the operating system.

2. Disconnect all external devices connected to the computer.

3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet

and then unplugging the AC adapter from the computer.

Component replacement procedures