User Guide

QuickSpecs
HP EliteDisplay S140u 14-inch USB Portable Monitor
c04346396—15101 —Worldwide — Version 7 — June 06, 2016
Page 7
Technical Specifications
Additional Information
This product is in compliance with the Restrictions of Hazardous
Substances (RoHS) directive - 2002/95/EC.
 This HP product is designed to comply with the Waste Electrical and
Electronic Equipment (WEEE) Directive – 2002/96/EC.
 This product is in compliance with California Proposition 65 (State of
California; Safe Drinking Water and Toxic Enforcement Act of 1986).
 Plastics parts weighing over 25 grams used in the product are marked per
ISO 11469 and ISO1043.
 This product contains 0 % post-consumer recycled plastic (by wt.)
 This product is 99.2 % recycle-able when properly disposed of at end of life.
Packaging Materials External:
PAPER/Cardboard & misc 363 g
Internal:
PLASTIC/Polyethylene low density 155 g
RoHS Compliance
Hewlett-Packard is committed to compliance with all applicable environmental
laws and regulations, including the European Union Restriction of Hazardous
Substances (RoHS) Directive. HP’s goal is to exceed compliance obligations by meeting
the requirements of the RoHS Directive on a worldwide basis. By July 1, 2006, RoHS
substances will be virtually eliminated (virtually = to levels below legal limits) for all
HP electronic products subject to the RoHS Directive, except where it is widely
recognized that there is no technically feasible alternative (as indicated by an
exemption under the EU RoHS Directive).
Material Usage
This product does not contain any of the following substances in excess of
regulatory limits (refer to the HP General Specification for the Environment at
http://www.hp.com/hpinfo/globalcitizenship/environment/pdf/gse.pdf):
 Asbestos
 Certain Azo Colorants
 Certain Brominated Flame Retardants – may not be used as flame
retardants in plastics
 Cadmium
 Chlorinated Hydrocarbons
 Chlorinated Paraffins
 Formaldehyde
 Halogenated Diphenyl Methanes
 Lead carbonates and sulfates
 Lead and Lead compounds
 Mercuric Oxide Batteries
 Nickel – finishes must not be used on the external surface designed to be
frequently handled or carried by the user.
 Ozone Depleting Substances
 Polybrominated Biphenyls (PBBs)
 Polybrominated Biphenyl Ethers (PBBEs)
 Polybrominated Biphenyl Oxides (PBBOs)
 Polychlorinated Biphenyl (PCB)
 Polychlorinated Terphenyls (PCT)