Installation manual

FuelMaster
®
Installation Manual
89

In the Monitor Mode, no authorization signal is required so nothing needs to be connected to the
Pedestal I/O Board LN and LD positions. FMU firmware activates the relay for the hose put in
Monitor Mode. An LED on the Relay Assembly corresponding to the activated relay will
illuminate steady while in Monitor Mode.
Pulses from a pulser or flowmeter are needed, so connections are made to the Pedestal I/O
Board pulser connectors on J4, J5, J6, and/or J7, as needed. The Monitor Mode monitors
incoming pulses and records a transaction after 10,000 pulses or once per day, whichever
occurs first.
Any of the eight hose positions in the FMU can be configured for the Monitor Mode. Monitor
Mode may be turned on through the use of a laptop connection, or with a Supervisor Prokee
®
or
Smartcard. If a Supervisor Prokee
®
or Smartcard are used to configure Monitor Mode, the only
option is to enable all hoses with Monitor Mode. If performed with a laptop connection (or by the
Customer Satisfaction Center), individual hoses may be configured.
Perform the following to configure Monitor Mode:
1) With a laptop connection:
a) Make a laptop connection in accordance with Product Bulletin 111.
b) Use the 54 command to display the Pump Mode Menu.
c) Select the hose position (A-H) to modify by typing the hose letter and depressing Enter.
The Pump Mode Configuration Menu will be displayed.
d) Depress 5. Enable Monitor Mode. The Pump Mode Menu will be displayed and show
the selection of Monitor Mode.
e) Depress <ESC>=Exit. The prompt CONFIGURATION HAS CHANGED. WOULD YOU
LIKE TO SAVE IT? (Y/N) will appear.
f) Depress Y to save the configuration change. The prompt Saving Configuration
Changes… PUMP #__ -> MONITOR MODE ENABLED Save Complete! will be
displayed.
g) Use the 07 command to exit the laptop connection.
2) With a Supervisor Prokee
®
or Smartcard:
a) Insert a Supervisor Prokee
®
or Smartcard. The SUPV: menu will appear.
b) Select B=ISSUES. The SUPERVISOR ISSUES MENU will appear.
c) Select B=MODE. The MODE MENU will appear.
d) Select B=MONITOR. The SUPERVISOR MONITOR MODE MENU will appear.
e) Select A=TURN ON. The prompt ALL ACTIVE PUMPS IN SEMI MANUAL MODE –OR-
MONITOR MODE! will appear.
f) Depress D=EXIT to exit the Supervisor menus.
7. Pulse Inputs
NOTE
AC ground cannot be substituted for 0V in pulser applications.
Pulse inputs are necessary to register quantity. Pulse inputs are made to receptacles J4 (hoses A
and B), J6 (hoses C and D), J5 (hoses E and F), and J7 (hoses G and H) located at left center on the
Pedestal I/O Board. The +12V positions are sending 12 VDC to the pulsers. This 12 VDC is constant
whenever power is applied to the FMU, and the FMU power switch is on. The P_ (P1 for hose A, P2
for hose B, etc.) positions are receiving pulses from the pulsers. The 0V positions are common or
ground. The OK_ (OK1 for hose A, OK2 for hose B, etc.) positions are for 12 VDC pump handle or
switch detection.
The +12V and 0V positions are not tied to a specific P_ position. Any +12V or 0V position may be
used with any P_ position. Since there is only one 0V position for every two P_ positions, two
conductors must be connected to each 0V position when 0V connections are required.
See Figures 4-15 through 4-21 for pulser connection diagrams. Typical connections to mechanical
265