Installation manual

FuelMaster

Installation Manual



Section 4

FMU Installation

Introduction

Following are procedures for installing a complete FuelMaster

Fuel Management System including

optional equipment. Detailed planning and preparation for these procedures was covered in Section 3,

Site Planning and Preparation.

All the following procedures may not have to be performed, nor may they have to be performed in the

order shown. It is recommended that these procedures be read and applied to each application before

proceeding with any work. If questions arise, contact Syn-Tech's Customer Satisfaction Center (800-888-

9136, ext. 1500) for assistance.

Initialization may be performed in conjunction with Installation. When both operations are being performed

by the same installer, it is recommended the installer spend some time with the customer to setup the

Central Controller, load the software, and perform some Central Controller training prior to progressing to

the other hardware installations. This will permit the customer time to develop the necessary databases

and encode Prokee

s or Smartcards that may be required to test the hardware after installation.

Unpacking and Inspection

NOTE

Vibration and rough handling could cause attaching parts to work loose during shipment. Do not

dispose of packing materials until all components listed on the packing list are accounted for.

The FMU is disassembled before shipment and packed in two boxes. The FMU pedestal is packed in a

54" x 18" x 12-1/2" box, and the upper cabinet and accessory materials (i.e., software, encoder, manuals,

Prokee®s, Smartcards, etc.) are packed in a 26" x 19" x 18" box. The components are packed in plastic

bags then placed in the shipping box where a liquid packing foam is injected to protect the components in

shipment. The EIU is shipped in one box 66” x 14” x 14”. The EIU Cabinet is separated from the EIU

Pedestal.

The serial number of the components which make up each FMU is written on the outside of the shipping

containers. Example: “3469, 1 of 2”; “3469, 2 of 2”. Keep the upper cabinet matched to the pedestal. This

will be necessary to apply an FMU activation code after the installation is completed and power is applied.

There is no other method of matching the FMU upper cabinet to the pedestal.

Unpack the boxes and inspect the contents against the packing list. The FMU and accessory material

packing list is affixed to the FMU pedestal box. The EIU packing list is affixed to the single EIU shipping

box. Check for any missing equipment or signs of damage from shipment. Verify the components shown

on the packing list match the customer’s requirements. If anything is not correct, it should be noted and

corrected before the installation proceeds. Contact Syn-Tech Systems’ Customer Satisfaction Center

(800-888-9136, ext. 1500) as soon as possible if any damage is noted or anything is missing.

239