Installation manual

Acceptance Test Procedure (ATP)
for Upgrades and Installations of
FuelMaster
®
Fuel Management Units
At Retail Sites
This ATP applies to upgrades and installations of Classic and Plus Fuel Management Units (FMUs)
installed at retail sites. Complete an ATP for each site. Place a check mark () in the space provided for
each step performed. Some procedures will not be applicable to all installations. Mark NA for those
procedures which are not applicable. Some procedures may be repeated for multiple FMUs. Add
comments and explain any deviations on page 6.
SITE:
LOCATION:
1. SITE EXAMINATION
a. All site equipment is operational, and installed in accordance with the NEC (if not, explain in
Comments on page 6).
b. Dispensing equipment has minimum of 100:1 pulser, or is capable of being set to 100:1.
c. Dispensing equipment has check valves to prevent draining hose.
d. Reset quantity counter on dispensing equipment, then turn on pump to fill hose. Does
quantity register on dispensing equipment before delivering fuel?
YES / NO (circle one). If YES, perform step 4q.
e. A dedicated phone line is available for credit card authorization at the FMU.
2. FMU UPGRADE
(For FMU Upgrades Only). Repeat for multiple FMUs. Note deviations on page 6.
a. Verify the FMU to be upgraded is operational.
b. Retrieve transactions, unit configuration, and options from FMU to be upgraded.
c. Use a laptop connection with command cc to determine credit card setup so it may be
restored after upgrade.
d. Upgrade the FMU.
e. Use a laptop connection to:
1) Initialize FMU (commands 02, FF, 1A, 28, FE).
2) Set/verify site signature (command 38).
3) Set system type and, if necessary, lock baud rate down (command 59).
4) Restore options (various commands).
5) Restore credit card configuration (command cc).
f. Using the customer’s computer, upload the site configuration, authorization list, and send
pricing, as required. Set PUMP HANDLE to START AND END, END ONLY, or YES to print
receipt as soon as pump handle/switch is turned off.
1 of 7
323